It is a traditional bar bending equipment with manual assist loading and unloading. It has experienced many years of market verification with stable production, simple operation, high quality and low price.

Video

Technical parameters

Equipment Model	LYWQ-32
Bar diameter	10mm	12mm	14mm	16mm	18mm	20mm	22mm	25mm	28mm	32mm
Bending quantity	7	6	5	4	3	3	2	2	1	1
Rate of bending	8r/min
Head movement speed	1m/s
Equipment power	12.6KW
Number of operators	2 persons
Occupied area	12m×2.2m

The vertical CNC steel bar bending center is a device with a high degree of automation, and each single machine can act independently and coordinate with each other. If the use of equipment by personnel who are not familiar with the machine is easy to cause accidents, it will cause damage to personnel or machines. Therefore, the operator of the equipment must be strictly trained, familiar with the functions, characteristics and operation methods of the machine, and operate in strict accordance with the requirements of the user manual.

Pre-start-up Preparation

1. Operators must wear safety helmets and protective gloves, otherwise they are not allowed to enter the site.
2. Confirm that there are no other non-operators around the machine, in case of accidents causing irreparable consequences.
3. In order to make the machine have a good working condition, before starting, grease should be added to the ready lubrication point.
4. Check whether the gear oil in the gear box is sufficient, the gear oil should be in the middle of the oil target, and the oil level should be added in time.
5. Check whether the bending shaft and center shaft can be used normally.
6. Check whether the air source and power supply are connected.
7. Check whether the electrical circuit switch is normal; Check whether each air pipe is intact.