Fully Automatic Steel Bar Bending Center
It is a traditional bar bending equipment with manual assist loading and unloading. It has experienced many years of market verification with stable production, simple operation, high quality and low price. The raw materials are stored in multistage silos. Different specifications of bars automatic switch matching magnetic feeding mechanism to realize multiple steel bars forming at one time, and the efficiency is stable and efficient.
The vertical CNC steel bar bending center is a device with a high degree of automation, and each single machine can act independently and coordinate with each other. If the use of equipment by personnel who are not familiar with the machine is easy to cause accidents, it will cause damage to personnel or machines. Therefore, the operator of the equipment must be strictly trained, familiar with the functions, characteristics and operation methods of the machine, and operate in strict accordance with the requirements of the user manual.
Pre-start-up preparation
1. Operators must wear safety helmets and protective gloves, otherwise they are not allowed to enter the site.
2. Confirm that there are no other non-operators around the machine, in case of accidents causing irreparable consequences.
3. In order to make the machine have a good working condition, before starting, grease should be added to the ready lubrication point.
4. Check whether the gear oil in the gear box is sufficient, the gear oil should be in the middle of the oil target, and the oil level should be added in time.
5. Check whether the bending shaft and center shaft can be used normally.
6. Check whether the air source and power supply are connected.
7. Check whether the electrical circuit switch is normal; Check whether each air pipe is intact.
Parameters
Equipment Model：LYZD-WQ32
|
Bar diameter (Single) |
12-32mm |
|
Bar diameter (Double) |
12-25mm |
|
Raw material storage method |
Compartmentalized bunker truck |
|
Raw material loading method |
Magnetic type |
|
Cutting method of raw material |
Hydraulic |
|
Hydraulic pressure |
≤16MPa |
|
Gas pressure |
≤0.8MPa |
|
Rated power of equipment |
24KW |
|
Number of operators |
1 person |
|
Production efficiency |
24 tons/10 hours |
|
Occupied area |
24m×6m |
Hot Tags: Fully Automatic Steel Bar Bending Center, China Fully Automatic Steel Bar Bending Center manufacturers, suppliers, factory
